Harrow Macro.

[sabak]

How do i write a successful Shadow Step / Harrow macro.

Simply putting them on two lines doesn't work for me. I had to use the macro record on the G15 keyb, which also fails sometimes, also if I move and it it, the NPCs start running off. I asume everyone get that.

[Lightning]

it should be something like:

/cast "name of spell / ability"

One line for each ability, and they have to be the exact name, so if you have "Harrow I" you'll need to make sure the "I" goes into the name, and keep updating it each time you get an upgrade.

[Xaices]

Use the following:

/cast "Shadow Step"
/cast "Harrow I"

Make sure you put in the level of Harrow I, II, III, IV etc.

For fun you can thro an emote in there I use this personaly.

/cast Shadow Step"
/emote steps into the shadows.
/cast "Harrow VI"

[sabak]

Thanks, thats what I was doing. But it doesn't work well for me.

If I remember it right there was some green message about warping.

Bare in mind, I play from Sweden now and I never have a ping under 330ms to these servers.

Ill check it out again tonight though..

[XeroKill]

The macro that Xaices provided is the same one I use and it works fine. It could be issues with your connection because after you induce shadow step if you don't input a second ability within a certain amount of time the ability will fail.

I use it constantly and it works fine for me.

A tip: In case you didn't, write the macro exactly as it is written above including the quotation marks, the capitalization, the spaces, everything. It is case sensitive and it needs the quotations and the appropriate spell level if it has one. Also, the number of the spell is in Roman Numerals, so "Harrow I" is with the letter I, not the number 1.

Remember, the second macro is missing a quotation mark in front of Shadow Step. it should be:

/cast "Shadow Step"
/em steps into the shadows.
/cast "Harrow I"